1996 MERCURY COUGAR 2DR COUPE
Security
Battery BLK/ORG + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Starter01 RED/LT.BLU(+) (+) IGNITION SWITCH HARNESS
AllDoorTrigger BLK/LT.BLU (-) LIGHT UNDER DASH
TrunkTrigger LT.GRN/YEL(-) (-) OR BLK AT TRUNK LIGHT SWITCH
HoodTrigger N/A
FactoryAlarmDisarm DK.GRN/VIO(-) DRIVER'S KICK PANEL
ParkingLights BRN (+) LIGHT SWITCH HARNESS
Remote Start
Battery BLK/ORG + (+) IGNITION SWITCH HARNESS
Ignition RED/LT.GRN (+) IGNITION SWITCH HARNESS
Ignition02 +
Ignition03 +
Accessory01 GRY/YEL + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 RED/LT.BLU(+) (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
Tach PNK/WHT AC (AC) AT MULTI COIL PACK
SpeedSense GRY/BLK (AC) TRANSMISSION
ParkingLights BRN (+) LIGHT SWITCH HARNESS
BrakeLights BLK/PNK (+) AT BRAKE SWITCH
Horn VIO/ORG (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock PNK/LT.GRN (-) TO TEST" W/KEYLESS NEG TRIG SAME LOCATIO
PowerLock PNK/YEL (-) DRIVER'S KICK REV POLARITY "USE PASS SW
Doorlocks / Windows
Power UnLock
(REV) ON MODELS WITHOUT KEYLESS
PowerLock
(REV) ON MODELS WITHOUT KEYLESS
Convenience
HeadLights RED/YEL (+) AT LIGHT SWITCH
LowSpeedWipers BLK/ORN (+) AT FIREWALL CONNECTOR
TrunkRelease VIO/YEL (+) AT DRIVER'S KICK OR AT SWITCH IN CONSOLE
Mobile Audio / Video
Battery BLK/ORG + (+) IGNITION SWITCH HARNESS
Accessory01 GRY/YEL + (+) IGNITION SWITCH HARNESS
Ground BLK/LT.GRN (-) RADIO HARNESS
Illumination LT.GRN (+) RADIO HARNESS
PowerAntenna AMP=DK.BLU
AMPTurnOn DARK BLUE (+) RADIO HARNESS
FrontLeftSpeakerPos ORN/LT.GRN
FrontLeftSpeakerNeg LT.BLU/WHT
FrontRightSpeakerPos WHT/LT.GRN
FrontRightSpeakerNeg DARK GREEN/ORANGE
RearLeftSpeakerPos PNK/LT.GRN
RearLeftSpeakerNeg TAN/YEL
RearRightSpeakerPos PNK/LT.BLU
RearRightSpeakerNeg BRN/PNK
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
